Kj
I have a 2001 Chevy Impala i recently purchase from a used car dealership. The car remote doesnt work. I look up info on it and i now you have 2 do the FOB settings thing. So when i Do all the steps and it says hold the lock and unlock button until you hear the chime. I hear the chime but the car remote still doesnt work . I was wonder if anyone could help me with this . Am i missing a step or doing something wrong
PS.Took it back to the car dealership they dont know how to fix it
Answer
1. Turn the ignition to ACC or ON and the radio to off. Do not crank the engine.
2. Press and hold the DISP button on the radio for at least five seconds until settings is displayed.
3. Press the SEEK up or down arrows until FOB PROG appears on the display.
4. Press the PREV or NEXT button to enter the submenu. The current selection will have an
asterisk next to it. BEGIN will be displayed.
5. Press the DISP button to start programming. When the message PUSH FOB flashes, press and
hold the LOCK and UNLOCK buttons on the first transmitter at the same time for 15 seconds. A
chime will be heard to verify the transmitter is learned.
6. Repeat Step 5 for each additional transmitter up to four remotes total. You do not need to press
the DISP button again, just press down the LOCK and UNLOCK buttons on the next transmitter
to be learned to a maximum of four transmitters per vehicle.
The mode you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle.
EXIT (Exit Feature Customization Mode): This feature allows you to exit the vehicle customization programming.
To Exit:
1. Scroll until EXIT appears on the display.
2. Press the DISP button to exit programming. A chime will he heard to verify the exit.
If you followed these steps and your remote still will not work the dealer CAN correct this problem.Best of luck.
1. Turn the ignition to ACC or ON and the radio to off. Do not crank the engine.
2. Press and hold the DISP button on the radio for at least five seconds until settings is displayed.
3. Press the SEEK up or down arrows until FOB PROG appears on the display.
4. Press the PREV or NEXT button to enter the submenu. The current selection will have an
asterisk next to it. BEGIN will be displayed.
5. Press the DISP button to start programming. When the message PUSH FOB flashes, press and
hold the LOCK and UNLOCK buttons on the first transmitter at the same time for 15 seconds. A
chime will be heard to verify the transmitter is learned.
6. Repeat Step 5 for each additional transmitter up to four remotes total. You do not need to press
the DISP button again, just press down the LOCK and UNLOCK buttons on the next transmitter
to be learned to a maximum of four transmitters per vehicle.
The mode you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle.
EXIT (Exit Feature Customization Mode): This feature allows you to exit the vehicle customization programming.
To Exit:
1. Scroll until EXIT appears on the display.
2. Press the DISP button to exit programming. A chime will he heard to verify the exit.
If you followed these steps and your remote still will not work the dealer CAN correct this problem.Best of luck.
Do FM transmitters for IPOD's show any info on Car Stereo Display?
mark.winte
Do FM transmitters transmit song information down the RDS channel to my car stereo. I have read that some do, what exactly shows up on the radio screen
Answer
I have an itrip wireless. Nothing but the frequency shows on the display.
I have an itrip wireless. Nothing but the frequency shows on the display.
Powered by Yahoo! Answers
No comments:
Post a Comment